[kepler-dev] PortParameters Bug?

[Daniel Higgins]

Hi All,

    I was just looking at the "RunLVPredPrey.xml" workflow in the 
'workflow/eco' subdirectory. This workflow always shows an n1int of '2' 
and an n2init of '10', no matter what the top level parameters are set to!

    The problem seems to be due to the use of a Composite actor in the 
workflow which uses PortParameters for input (rahter than the more 
common Port). It seems that the parameter value is ALWAYS used rather 
than the port token! And trying to remove the port value gives an error.

    It was my understnding that a PortParameter was supposed to use the 
parameter if there was no token in the port and the port value if there 
was a token. Am I misunderstanding what is supposed to happen? Or is 
there a bug here?

Dan

-- 
---------------------------------
Dan Higgins
Software Developer
National Center for Ecological Analysis and Synthesis (NCEAS) 
735 State St. Rm 205 
Santa Barbara, CA 93101 
805-892-2531 
higgins at nceas.ucsb.edu 
---------------------------------