[kepler-users] token duplicator

Dan Higgins higgins at nceas.ucsb.edu
Fri Feb 23 10:40:17 PST 2007


Good question! I also see the same error message when used under a SDF 
director, but the actor apparently works if used in a workflow with a PN 
Director. Not sure why.

If you need to use a SDF director, try the Repeat actor. I think it is 
supposed to do the same thing (duplicate input tokens) but the number of 
duplications is set by an internal parameter rather than through an 
input port.

Dan Higgins

---

Izabell Caraconcea wrote:
> Hi All,
> I'm confused about this actor, Token Duplicator. What is the output? I 
> looked into the code and saw an array and the array length. Then, 
> why the output port is not multi instead of single? I have connected 
> the actor with several other actors and got the error message "queue 
> is at capacity 1". 
> Any suggestion?
>  
> Thanks!
> Izabell 
> ------------------------------------------------------------------------
>
> _______________________________________________
> Kepler-users mailing list
> Kepler-users at ecoinformatics.org
> http://mercury.nceas.ucsb.edu/ecoinformatics/mailman/listinfo/kepler-users
>   


-- 
*******************************************************************
Dan Higgins                                  higgins at nceas.ucsb.edu
http://www.nceas.ucsb.edu/    Ph: 805-893-5127
National Center for Ecological Analysis and Synthesis (NCEAS) Marine Science Building - Room 3405
Santa Barbara, CA 93195
*******************************************************************




More information about the Kepler-users mailing list